. SAFETY PRECAUTIONS FOR MAINTENANCE 2 - 34 DO NOT DISASSEMBLE RECOIL S Never attempt to disassemble the recoils spring assembly. It contains a spr ing under hig h pressure whi ch serves as a shock absorber for the idler. If it is disassembled by mistake, the sprin g will fly out and cause seri ous injury. When it becomes necessary to di sassemble it, ask your Komatsu distributo r to do the w PRECAUTION WITH HIGH-PRESS URE OIL nder internal pressure. When inspecting or replacing piping or hoses, always The hydraulic system is always u check that the pressure in the hyd raulic circuit has been released.
If t he circ uit is still und er pressure, it will lead to serious injury, so always do as fol lows. details, see "PROCEDURE FOR RELEASING INTERNAL PRESSURE IN Release the pressure. For IN HYDRAULIC CIRCUIT (PAGE 4-41)". Do not carry out inspection or rep lacement wh ile the circuit is still under pressure. If there is any leakage from the piping or hoses, the surrounding area will b e wet, so che ck for cracks in the piping and hoses and for swelling in t he hoses. r safety glasses and leather gloves. sure oil leaking from small holes use blindness if it contacts your jet of high-pressureoil and suffer the place with clean water, and r medical attention.
When carry out inspection, wea r safety glasses and leather gloves. There is a hazard that high-pres may penetrate your skin or ca eyes directly. If you are hit by a injury to your skin or eyes, wash consult a doctor immediately fo may penetrate your skin or ca eyes directly. If you are hit by a injury to your skin or eyes, wash consult a doctor immediately fo PRECAUTION FOR HIGH FUEL PR ESSURE High pressure is generated inside the engine fuel piping when the engine is r unning.
Wh en carrying out i nspection or maintenance of the fuel piping system, wait for at least 30 seconds after stopping the engine to let th pressure go down before starting HANDLING HIGH-PRESSURE HOS ES If oil or fuel leaks from high-pre ssure hoses, it may cause fire or defective operation, w hich may lead to serious injury. If any loose bolts are fou nd, stop work and tighten to the specified to rque. If any d amaged hoses are found, stop operations immediately an d contact your Komatsu distributor. Replace the hose if any of the foll Damaged or leaking hydraulic Frayed or cut covering or expo Covering swollen in places. Twisted or crushed movable p Foreign material embedded in