Deutz — 4.4 RENEWAL OF HYDRAULIC LIFT AND ASM CONTROL UNIT

4. PUTTING THE TRACTOR INTO SERVICE 4.4 RENEWAL OF HYDRAULIC LIFT AND ASM CONTROL UNIT 7 - Select 3rd gear, shift the shuttle lever to the “FORWARD” position and wait for the automatic procedure to finish. CAUTION Do not depress the clutch pedal or move the shuttle lever during the automatic procedure, as this could cause the program to abort and cancel. 8 - At the end of the calibration procedure, a message will appear confirming calibration successfully completed; at this point, exit the EDS program. 4.4 RENEWAL OF HYDRAULIC LIFT AND ASM CONTROL UNIT Whenever the lift control unit is renewed, the technician must carry out the following operations:

1 - program the type of tractor; 2 - configure no radar status; 3 - calibrate the lift position sensor: up down; 4 - check and calibrate the lift control lever. The purpose of identifying the type of tractor and calibrating the sensors is to inform the control unit of the parameters it must use to pilot and monitor the operation of the lift correctly. To perform the calibration, connect the ART to the connector in the control units compartment of the cab, then select EHR+ from the “AVAILABLE TESTS” menu and proceed as described. 20-31