4. PUTTING THE TRACTOR INTO SERVICE 4.3 RENEWAL OF THE TRANSMISSION CONTROL UNIT 4 - From the main menu, select “DEST45” on the “CONTROL” menu. 5 - Select “END-OF-LINE PROGRAMMING” from the “CONTROL” menu. NOTE Make certain that the transmission oil is at approximately 40 °C, using “DATA - PLAIN TEXT DISPLAY” from the DI- AGNOSIS menu, and check that the shuttle lever is positioned at “NEUTRAL”. 6 - Throttle the engine to 1500 rev/min., select a ratio between 3rd M and 1st L, then click “2” to initiate the sensor cal- ibration procedure. 20-30