4. PUTTING THE TRACTOR INTO SERVICE 4.4 RENEWAL OF HYDRAULIC LIFT AND ASM CONTROL UNIT 4.4.3 CALIBRATION OF THE LIFT POSITION SENSOR NOTE This operation must be carried out with the engine run- ning on idle, the parking brake applied and the shuttle lever in the neutral position. 1 - From the main menu, press “ 3 ” to bring up the CALIBRATIONS ” menu. 2 - Unlock the hydraulic lift by setting the control lever to the “ STOP ” position for around two seconds (after which, the indicator Led will stop blinking). NOTE If the lift control lever is already in the “STOP” position, move it away and then back again to the “STOP” po- sition.
3 - Press 4 - Press the 'Down' button to lower the lift completely (as the lift links descend, the “ Actual ” value should decrease continuously). 5 - When the lift has reached its lower travel limit, press E ” to memorize the value. 20-34 S E T T I N G M E N U = = = = = = = = = = = = = = = = 1 - M i n H e i g h t 0 . 9 4 2 - M a x H e i g h t 4 . 0 2 3 - L o c k S p e e d 2 0 4 - S l i p a g e % 1 0 - - - M a i n L e v e r - - - 5 - T r a n s p o r t 5 . 3 6 6 - S t o p 3 . 6 6 7 - C o n t r o l 1 . 9 2 8 - F l o a t 1 . 4 5 = = = = = = = = = = = = = = = = [ E ] E x i t M i n . H e i g h t = = = = = = = = = = = = = = = = A c t u a l : 0 . 9 4 N e w : 0 .
9 2 [ D ] D e l e t e [ E ] E x i t M i n . H e i g h t = = = = = = = = = = = = = = = = A c t u a l : 0 . 9 4 N e w : 0 . 9 2 [ A ] C a n c e l [ C ] C o n f i r m