Deutz — 5.1.4 ANALYSIS OF LIFT AND ASM ALARMS

5. ALARMS 5.1 LIFT AND ASM CONTROL UNIT ALARMS Extended alarm: 64 WheelSensNotConn. Standard alarm: 42 DESCRIPTION The engine control unit detects that the signal from the wheel speed pickup is either non-existent or incorrect. NOTA If, when this alarm is triggered, the Infocenter continues to indicate the ground speed, the fault will be on the line between the Infocenter and the transmission control unit; conversely, if the speed is not indicated with the ma- chine in motion, the problem is in the connection between the wheel sensors, the transmission control unit and the Infocenter (for details on how to identify the fault, see transmission alarm N° 47).

CHECK Check that the contacts on connector “ST1” of the Infocenter, connector “X8” of the engine control unit circuit board, connector “MX2” of the engine control unit and connectors “JX1” and “JX2” of the lift control unit, are all firmly attached and not oxidised. Check with the SERDIA program that the engine control unit is receiving the ground speed signal. If the signal is being acknowledged, renew the lift control unit. Connect a test meter to pin 11 of connector “ST1” and pin 19 of connector “JX2”, and measure the resistance to verify the continuity of the circuit (meter reading: 0 Ohm).

With the starter key in the “O” (OFF) position, connect a test meter to pin 19 of connector “JX2” and to cab earth, and measure the resistance to verify that there are no short circuits to earth (meter reading: infinity). With the starter key in the “I” (ON) position, connect a test meter to pin 19 of connector “JX2” and to cab earth, and check that there are no short circuits to positive (meter reading: 0V). Clear all alarms, turn the starter key first to “O” (OFF) and then back to the “I” (ON) position again, and if the alarm is still present, the control unit must be renewed. 20-67 5:51/:& ?1 4 /5 1= >?/ ?& ",- .

4 9 * / 3(0 $?/ 4 / !0 " 614 5 1:=400 0 1/ = / 11 (1 *+ *+    ( #$%%&'() 5:51/:&&= :  4 /5 4 / 4 9 0 1/ = / 11 *+ *+   #$%%&'() (