5. ALARMS 5.2 LIST OF TRANSMISSION CONTROL UNIT ALARMS 5. ALARMS 5.2 LIST OF TRANSMISSION CONTROL UNIT ALARMS The transmission control unit warns the operator of any malfunction affecting monitored components, by way of audible signals, and messages generated in the display on the right hand front upright of the cab. A fault is indicated by the appearance of a symbol (key) in the display, accompanied by a code and in certain instances by an acoustic signal. In the event of two or more alarms being activated simultaneously, the display will show only the one with the higher code.
All alarms presented on the display correspond directly to the alarm conditions detected via EDS, apart from a certain number associated with malfunction of the connection between the control unit and the display, which are shown on the display with the “EE” alarm code. In addition to coded alarms, there are also conditions in which the control unit is unable to diagnose the cause of the fault; these are identifiable from abnormalities in operation of the transmission. Depending on the severity of the fault by which it is triggered, a given alarm can have a limiting effect on the way the trans- mission is managed.
In many instances, where the fault is not serious, a warning appears in the display and the operation of the transmission re- mains substantially unaffected, whereas in other cases, the warning is displayed and operation will be totally inhibited, or in less serious cases, simply limited. 5.2.1 ABNORMALITIES NOT DETECTED BY THE TRANSMISSION CONTROL UNIT 5.2.2 ALARMS INDICATED ON THE TRANSMISSION DISPLAY AND BY THE EDS PROGRAM 20-79 Abnormality Pag.
EDS software unable to connect to the transmission control unit (GEN1) 20-136 Transmission slips unexpectedly from forward or reverse drive into neutral (GEN2) 20-137 Transmission continues to shift range automatically every 1 or 2 seconds (GEN3) 20-137 Momentary loss of traction with the tractor in motion (GEN4) 20-138 Transmission stays permanently in neutral (GEN5) 20-138 Alarm code Alarm description Operating mode Page 11 The control unit detects errors in the main clutch calibration values. 20-84 12 The control unit detects a problem with the power input to the trans- mission oil temperature sensor.
20-85 13 The control unit detects a problem with the power input to the tem- perature sensor. 20-86 14 The control unit detects a discrepancy between the speeds sensed at the main clutch input and at the transmission output, indicated by the status of the start enable sensor (which indicates whether the transmission is in neutral or gears are engaged) 20-87 15 The control unit detects that the transmission oil low pressure in- dicator light is disconnected 20-88