Deutz — 5.2.4 ANALYSIS OF ALARMS

5. ALARMS 5.2 LIST OF TRANSMISSION CONTROL UNIT ALARMS ALARM N° 15 DESCRIPTION The control unit detects that the transmission oil low pressure indicator light is disconnected ECU RESPONSE. The control unit does not limit the operation of the transmission. CHECK Check that the contacts on connector “ST1” of the Infocenter and on that of the lift control unit, “ECU PS”, are firmly at- tached and not oxidised. With the starter key in the “O” (OFF) position, connect a test meter to pin 7 of connector “ST1” and pin 5 of connector “ECU PS”, and measure the resistance to verify the continuity of the circuit (meter reading: 0 Ohm).

If the Infocenter installed is a type 2, check that the lamp of the transmission oil low pressure indicator is not burnt out. Clear all alarms, turn the starter key first to “O” (OFF) and then back to the “I” (ON) position again, and if the alarm is still present, the transmission control unit must be renewed.

20-88 0.012.8732.4 1 2 5 21 23 45 68 2145 23 68 1 2 5 ECU PS GND4 J2 AS6 3 6 361 ST1 2 7 9 3 12 F35 F27 7.5A 7.5A +15 PRESSURE +30 GND GND BOX GEAR +15 +30 0441.9533 0.012.8894.4 D0017060 0.012.8732.4 1 2 5 21 23 45 68 2145 23 68 1 2 5 ECU PS GND4 J2 AS6 3 6 F35 F27 7.5A 7.5A +15 +30 0441.9533 361 ST1 2 7 9 3 12 +15 PRESSURE +30 GND GND BOX GEAR 0.012.8894.4 21 45 23 68 1 2 5 GND4 J2 3 36 1 2 7 9 3