5. ALARMS 5.2 LIST OF TRANSMISSION CONTROL UNIT ALARMS ALARM N° 14 DESCRIPTION The control unit detects a discrepancy between the speeds sensed at the main clutch input and at the transmission output, indicated by the status of the start enable sensor (which indicates whether the transmission is in neutral or gears are en- gaged). ECU RESPONSE The control unit does not limit the operation of the transmission. CHECK In the event that there are other alarms activated, relating to the main clutch speed sensor (nHk) and the engine speed sensor (nAb), verify the cause as described under the relative alarm headings before proceeding as follows.
Check that the contacts on connector “X80” of the start enable switch and on the lift control unit “ECU PS” are firmly attached and not oxidised. With the starter key in the “O” (OFF) position, connect a test meter to pin 1 of relay “RL40” and to engine earth, and measure the resistance to verify the continuity of the circuit with the mechanical shift in neutral (meter reading 0 Ohm) and a break in continuity when a gear is engaged (meter reading: infinity). Clear all alarms, turn the starter key first to “O” (OFF) and then back to the “I” (ON) position again, and if the alarm is still present, the transmission control unit must be renewed.
20-87 0.012.8732.4 1 2 31 21 23 45 68 2145 23 68 1 2 31 ECU PS 0 1 2 GND4 50 15 X 30 X17 J2 MS1 3 6 F35 F27 7.5A 7.5A +15 +30 0441.9533 31 20 GND2 +30 +50 3 1 2 5 RL40 2 1 X80 0.013.5915.4 D0022691 21 45 23 68 1 2 GND4 J2 3 3 1 2 0 0 1 2 50 15 X 30 3 1 2 2 1