Deutz — 5.2.4 ANALYSIS OF ALARMS

5. ALARMS 5.2 LIST OF TRANSMISSION CONTROL UNIT ALARMS ALARM N° 19 DESCRIPTION The control unit detects the transmission display control signal short-circuiting to earth ECU RESPONSE The control unit does not limit the operation of the transmission, but displays an error message “EE” and sounds a con- tinuous beep NOTE Alarm code 19, detectable only by way of the EDS program. CHECK Check that the contacts on connector “X40” of the display and on that of the lift control unit, “ECU PS”, are firmly at- tached and not oxidised.

With the starter key in the “O” (OFF) position and connector “X40” unplugged, connect a test meter to pin 14 of con- nector “ECU PS” and to cab earth, and measure the resistance to verify whether or not there are short circuits to earth (meter reading: infinity). If no short circuit to earth is discovered, fit a new display. Clear all alarms, turn the starter key first to “O” (OFF) and then back to the “I” (ON) position again, and if the alarm is still present, the transmission control unit must be renewed.

20-92 0.012.8732.4 1 2 14 21 23 45 68 2145 23 68 1 2 14 ECU PS GND4 J2 J3 AS5 3 6 6 3 1 5 F35 F27 F16 7.5A 7.5A 3A X40 1 5 6 2 +12V M M Sig +15 +30 +15 0441.9533 0443.7875 D0017080 0.012.8732.4 1 2 14 21 23 45 68 2145 23 68 1 2 14 ECU PS GND4 J2 J3 AS5 3 6 6 F35 F27 F16 7.5A 7.5A 3A +15 +30 +15 0441.9533 3 1 5 X40 1 5 6 2 +12V M M Sig 0443.7875 21 45 23 68 1 2 14 1 5 1 5 6 2 +12V M M Sig