Deutz — 5.2.4 ANALYSIS OF ALARMS

5. ALARMS 5.2 LIST OF TRANSMISSION CONTROL UNIT ALARMS ALARM N° 18 DESCRIPTION The control unit detects a discrepancy between the oil pressure reading and the operating status of the transmission ECU RESPONSE The control unit does not limit the operation of the transmission, but indicates the problem via the Infocenter CHECK In the event that there are other alarms activated, relating to the engine rpm sensors (nLse), verify the cause as de- scribed under the relative alarm headings before proceeding as follows. Check that the contacts on the “PRESS. SWITCH” transmission oil pressure sensor and connector “ECU PS” of the lift control unit are firmly attached and not oxidised.

Verify the correct operation of the sensor (for technical details, see section 40). With the starter key in the “I” (ON), position, check that the power input to the clutch pedal position sensor is correct (12V measured between pin 1 (positive) of connector “PRESS. SWITCH” and transmission earth) With the starter key in the “O” (OFF) position, connect a test meter to pin 2 of connector “PRESS. SWITCH” and pin 29 of connector “ECU PS”, and measure the resistance to verify the continuity of the circuit (meter reading: 0 Ohm). Check the pressure in the hydraulic circuit of the transmission system.

Clear all alarms, turn the starter key first to “O” (OFF) and then back to the “I” (ON) position again, and if the alarm is still present, the transmission control unit must be renewed. 20-91 0.012.8732.4 1 2 29 21 23 45 68 2145 23 68 1 2 29 ECU PS GND4 J2 TKAB1 3 6 37111 PS 1 F35 F27 7.5A 7.5A 1 LS/PS 2 1 PRESS. +15 +30 SWITCH P HK 0441.9533 0.012.8672.4 D0017071 0.012.8732.4 1 2 29 21 23 45 68 2145 23 68 1 2 29 ECU PS GND4 J2 TKAB1 3 6 F35 F27 7.5A 7.5A +15 +30 0441.9533 37111 PS 1 1 LS/PS 2 1 PRESS. SWITCH P HK 0.012.8672.4 21 45 23 68 1 2 29 GND4 J2 3 371 11 1 1 2 1 HK