5. ALARMS 5.2 LIST OF TRANSMISSION CONTROL UNIT ALARMS ALARM N° 64 DESCRIPTION The control detects a conflict in the information received from the clutch pedal position sensor and clutch pedal depressed sensor, regarding the position of the pedal ECU RESPONSE The control unit limits operation to “EMERGENCY DRIVE” mode, the transmission reverts to neutral and a continuous beep is sounded. CHECK In the event that there are other alarms activated, relating to the clutch pedal position sensor, verify the cause as de- scribed under the relative alarm headings before proceeding as follows.
Check that the contacts on connector “X33” and on connector “ECU PS” of the transmission control unit are firmly at- tached and not oxidised. Perform the clutch pedal position sensor calibration procedure. Verify the correct operation of the clutch pedal depressed proximity sensor (for details see section 40) Verify the correct positioning of the clutch pedal depressed proximity sensor. Verify the correct operation of the clutch pedal position sensor (for details see section 40) Clear all alarms, turn the starter key first to “O” (OFF) and then back to the “I” (ON) position again, and if the alarm is still present, the control unit must be renewed.
20-114 0.012.8732.4 1 2 4 21 23 45 44 68 2145 23 68 1 2 4 44 ECU PS GND4 J2 J3 AS6 AS3 3 6 6 F35 F27 F16 7.5A 7.5A 3A +15 +30 +15 0441.9533 8 4 9 X33 1 2 3 0.012.8894.4 D0017400 21 45 23 68 1 2 4 44 GND4 J3 AS6 3 8 4 1 2