5. ALARMS 5.2 LIST OF TRANSMISSION CONTROL UNIT ALARMS ALARM N° 65 DESCRIPTION The control unit detects that the clutch pedal position sensor is disconnected or short-circuiting to earth ECU RESPONSE The control unit limits operation to “EMERGENCY DRIVE” mode, the transmission reverts to neutral and a continuous beep is sounded. CHECK Check that the contacts on connector “X34” and on connector “ECU PS” of the transmission control unit are firmly at- tached and not oxidised. With the starter key in the “I” (ON) position, check that the power input to the clutch pedal position sensor is correct (5V measured between pin 1 (positive) and pin 2 (negative) of connector “X34”).
With the starter key in the “I” (ON) position and connector “ECU PS” unplugged, connect a test meter to pin 2 of con- nector “X34” and to transmission earth, and check that there is no voltage registering (meter reading 0V). With the starter key in the “O” (OFF) position, connect a test meter to pin 4 of connector “X34” and to pin 38 of connector “ECU PS”, and measure the resistance to verify the continuity of the circuit (meter reading: 0 Ohm). Verify the correct operation of the sensor (for technical details, see section 40).
Clear all alarms, turn the starter key first to “O” (OFF) and then back to the “I” (ON) position again, and if the alarm is still present, the control unit must be renewed. 20-115 0.012.8732.4 1 2 21 23 45 24 37 38 68 2145 23 68 1 2 38 3724ECU PS GND4 J2 AS6 3 6 3 2 1 F35 F27 X34 7.5A 7.5A 4 1 2 +15 +30 0441.9533 0.012.8894.4 D0017430 0.012.8732.4 1 2 21 23 45 24 37 38 68 2145 23 68 1 2 38 3724ECU PS GND4 J2 AS6 3 6 F35 F27 7.5A 7.5A +15 +30 0441.9533 3 2 1 X34 4 1 2 0.012.8894.4 21 45 23 68 1 2 38 37 24 GND4 J2 3 3 2 1 4 1 2