5. ALARMS 5.2 LIST OF TRANSMISSION CONTROL UNIT ALARMS ALARM N° 89 DESCRIPTION The control unit detects an abnormal level of current drawn by the main clutch solenoid valves and the forward and reverse solenoid valves Y1 and Y3 ECU RESPONSE The control unit limits operation to “TC-SHUTDOWN” mode and the transmission reverts to neutral, emitting a continuous beep. NOTE This alarm could be displayed as a result of alarms 94, 95 and 96 being activated.
CHECK With the starter key in the “O” (OFF) position and connector “ECU PS” unplugged, connect a test meter to pin B of connector “EV GROUP” and to the transmission earth, and measure the resistance to check for short circuits to earth (meter reading: infinity). Repeat the test on pin D for connector “EVGROUP” and on pin 1 of connector “EVPROP”. With the starter key in the “I” (ON) position and connector “ECU PS” unplugged, connect a test meter to pin A of connector “EV GROUP” and the transmission earth and check that there is no voltage (meter reading: 0V). Repeat the test on pin D for connector “EVGROUP” and on pin 1 of connector “EVPROP”.
With the starter key in the “I” (ON) position, connect a test meter to pins 23 and 68 and measure the voltage (meter read- ing: 12V) Clear all alarms, turn the starter key first to “O” (OFF) and then back to the “I” (ON) position again, and if the alarm is still present, the control unit must be renewed.. 0.012.8732.4 1 2 8 11 13 21 23 45 32 55 56 57 68 ECU PS TKAB1 F35 EV GROUP EV PROP 0441.9533 0.012.8672.4 Prop D0017611 20-128 21 45 23 68 1 2 11 8 57 32 13 55 56 GND4 J2 3 5 1 6 16 21 1 7 22 E F C D 4 2 3 2 1 U