5. ALARMS 5.2 LIST OF TRANSMISSION CONTROL UNIT ALARMS ALARM N° 91 DESCRIPTION The control unit detects a conflict between values read by the nLsa and nHk sensors, the position of the clutch pedal and the position of the creeper engagement lever ECU RESPONSE The control unit limits operation to “TC-SHUTDOWN” mode and the transmission reverts to neutral. CHECK Check that the creeper engagement lever is in the correct position and the sensor correctly placed. Verify the correct operation of the creeper engagement sensor (for details, see section 40). Make certain that connectors “NHK” and “NAB” have not been switched.
With the starter key in the “O” (OFF) position and connector “ECU PS” unplugged, connect a test meter to pin A of con- nector “EV GROUP”, and measure the resistance to verify whether or not there are short circuits to earth (meter reading: infinity). With the starter key in the “I” (ON) position and connector “ECU PS” unplugged, connect a test meter to pin 1 of connector “EV PROP” and the transmission earth and check that there is no voltage (meter reading: 0V). Check the transmission hydraulic system Clear all alarms, turn the starter key first to “O” (OFF) and then back to the “I” (ON) position again, and if the alarm is still present, the control unit must be renewed.
0.012.8732.4 1 2 8 11 13 21 23 45 32 55 56 57 68 ECU PS TKAB1 F35 EV GROUP EV PROP Prop D0017611 0441.9533 0.012.8672.4 20-130 21 45 23 68 1 2 11 8 57 32 13 55 56 GND4 J2 3 5 1 6 16 21 1 7 22 E F C D 4 2 3 2 1 U