Deutz — 5.3.1 ALARMS DISPLAYED USING THE SERDIA PROGRAM

5. ALARMS 5.3 LIST OF ALARMS DISPLAYED BY SERDIA 20-140 Alarm code Alarm description Page 42 Alarm code available but not utilised – 44 Alarm code available but not utilised – 50 The engine control unit has detected that the actuator position signal does not match the requirement. 20-152 52 The engine control unit has detected that the reference signal for the position of the actuator does not match the requirement. 20-153 53 The engine control unit has detected that the difference between the command and the response of the actuator is greater than 10%.

20-154 59 Alarm code available but not utilised – 60 Alarm code available but not utilised – 62 Alarm code available but not utilised – 63 Alarm code available but not utilised – 67 The engine control unit has detected the absence of a connection to the accelerator pedal po- sition sensor or a signal out of range. 20-155 68 Alarm code available but not utilised – 70 Alarm code available but not utilised – 71 Alarm code available but not utilised – 74 Alarm code available but not utilised – 76 The engine control unit has detected an error in writing the parameters. 20-156 77 The engine control unit has detected an error in reading the program memory during the normal control cycle.

20-156 78 The engine control unit has detected an error in reading the work memory during the normal control cycle. 20-156 80 The engine control unit detects an actuator power input outside the specified parameters. 20-156 83 The control unit detects that the power input to the accelerator pedal or hand throttle position sensor is either non-existent or incorrect. 20-157 84 The control unit detects that the power input to the turbo charge pressure sensor is non-existent or incorrect. 20-158 85 Alarm code available but not utilised – 86 The engine control unit detects that its internal temperature is too high.

20-159 87 The engine control unit detects that atmospheric pressure is outside the permitted limits. 20-159 90 The engine control unit has detected a discrepancy between the parameters written in EEPROM. 20-159 93 The engine control unit has detected a “Stack Overflow” error during execution of the program. 20-160 94 The engine control unit has detected an internal error. 20-160