5. ALARMS 5.3 LIST OF ALARMS DISPLAYED BY SERDIA 5. ALARMS 5.3 LIST OF ALARMS DISPLAYED BY SERDIA The engine control unit informs the operator of any malfunction affecting monitored components, both audibly and visually (fault warning light) by way of the Infocenter. Faults are indicated by the light using two types of visual warning: 1 - fault warning light flashing: this type of indication informs the operator that one of the components in the engine sys- tem is faulty, but normal operation of the engine remains unaffected. The engine continues to operate normally. 2 - fault warning light permanently on:
this type of indication informs the operator that one of the components in the en- gine system is faulty, and continuing to work under these conditions could result in serious damage to the engine. When this type of alarm occurs, the engine generally switches off and it will not be possible to operate the starter until the fault has been rectified.
5.3.1 ALARMS DISPLAYED USING THE SERDIA PROGRAM 20-139 Alarm code Alarm description Page 1 The engine control unit detects that the signal from the engine pickup is either non-existent or incorrect 20-141 2 Alarm code available but not utilised – 3 The engine control unit detects that the signal from the wheel speed pickup is either non-existent or incorrect. 20-142 4 Alarm code available but not utilised – 5 The control unit detects that the connection to the accelerator pedal position sensor is either non-existent or short-circuiting. 20-143 6 The control unit detects that the connection to the hand throttle position sensor is either non-existent or short-circuiting.
20-144 7 The engine control unit has detected that the engine turbo charge pressure signal is either non-existent or unreliable. 20-145 8 Alarm code available but not utilised – 9 The engine control unit has detected that the coolant temperature signal is either non-existent or unreliable. 20-146 10 Alarm code available but not utilised – 11 The engine control unit has detected that the fuel temperature signal is either non-existent or unreliable. 20-147 30 Alarm code available but not utilised – 31 The engine control unit has detected a coolant temperature higher than the alarm threshold.
20-148 32 Alarm code available but not utilised – 34 Alarm code available but not utilised – 35 The engine control unit detects that the engine is or has been running overspeed (above 3100 rpm). 20-149 36 The engine control unit has detected a fuel temperature higher than the alarm threshold. 20-150 40 Alarm code available but not utilised – 41 The engine control unit has detected a coolant temperature higher than the alarm threshold. 20-151