Deutz — 5.2.4 ANALYSIS OF ALARMS

5. ALARMS 5.2 LIST OF TRANSMISSION CONTROL UNIT ALARMS ALARM GEN4 DESCRIPTION Momentary loss of traction with the tractor in motion ECU RESPONSE None CHECK Reprogram the control unit, entering the correct tractor model data, and repeat the calibration procedure for the main clutch and the clutch pedal. Check the wiring, following the procedures described for alarms 53, 54, 55, 56, 57 and 58. Check the pressure in the hydraulic circuit of the transmission system. Clear all alarms, turn the starter key first to “O” (OFF) and then back to the “I” (ON) position again, and if the alarm is still present, the control unit must be renewed.

ALARM GEN5 DESCRIPTION The transmission stays in neutral CHECK Check that the contacts on connector “X80” of the start enable switch and on connector “ECU PS” of the lift control unit are firmly attached and not oxidised. With the starter key in the “O” (OFF) position, connect a test meter to pin 1 of relay “RL40” and to engine earth, and measure the resistance to verify the continuity of the circuit with the mechanical shift in neutral (meter reading 0 Ohm) and a break in continuity when a gear is engaged (meter reading: infinity).

With the starter key in the “O” (OFF) position, connect a test meter to pin 1 of relay “RL40 and to pin 31 of connector “ECU PS”, and measure the resistance to verify the continuity of the circuit (meter reading: 0 Ohm). Clear all alarms, turn the starter key first to “O” (OFF) and then back to the “I” (ON) position again, and if the alarm is still present, the transmission control unit must be renewed. 20-138