5. ALARMS 5.4 LIST OF FRONT AXLE SUSPENSION CONTROL VALVE ALARMS ALARM N° 15 PO. SE. Fa. or NC DESCRIPTION The control unit detects that the front suspension position sensor is disconnected. CHECK Check that the contacts on connector “X69” of the front axle suspension position sensor and connector “JX4” of the control unit are firmly attached and not oxidised . With the starter key in the “I” (ON) position, check that the power input to the front suspension position sensor is correct (8 Vdc approx measured between pin 3 (positive) and pin 1 (negative) of connector “X69”). Check for electrical continuity between pin 14 of connector “JX4” and pin 2 of connector “X69”.
With the starter key in the “O” (OFF) position, connect a test meter to pin 2 of connector “X69” and to transmission earth, and measure the resistance to verify that there are no short circuits to earth (meter reading: infinity). Verify the correct operation of the sensor (for technical details, see section 40). If the fault persists, renew the control unit. 20-167 0443.7850 14 17 9 20 5 4 17 14 9 JX4 20 4 5 JX3 3 8 FE2 0.012.8732.4 FE1 GND4 J2 4 5 6 1 2 3 X69 U S 0443.7849 7 F17 7.5A +15 0441.9533 D0017240 17 14 9 4 5 6 1 2 3 U S 20 4 5 3 8