6. OPERATOR’S MANUAL EDS (Electronic Diagnosis System) 1. GENERAL INTRODUCTION 6. OPERATOR’S MANUAL EDS (Electronic Diagnosis System) 1. GENERAL INTRODUCTION The electronic components in the AGROTRON are tested and programmed by means of the Electronic Diagnosis System (EDS) from DEUTZ-FAHR. The existing version of the EDS consists of an interface cable and an adapter cable as well as of an installation disk with the corresponding programs. The PC program and the cables are distributed via: SAME-DEUTZ-FAHR ITALIA S.p.A. 24047 TREVIGLIO (BG) - ITALIA Viale F. CASSANI, 15 1.1 FUNCTIONAL SCOPE The EDS software includes the following subprograms:
POWERSHIFT (not used for this tractor) and POWERSHUTTLE transmission - Diagnosis - Readout of the gear box error memory - Programming of the gear box, e.g. upon replacement of the box (end-of-line programming) - Calibration of the sensor at the clutch pedal (end-of-line programming) - Evaluation of the contact pressure of the main clutch (only for power shuttle) Agrotronic-hD (not used for this tractor) - Diagnosis - Readout of the AGROTRONIC-hD box error memory - Calibrate valves Infocenter - Diagnosis - Programming of the constant values Spring-suspended front axle (not used for this tractor) - Diagnosis - Readout of the control box error memory - Reading resp.
loading of the control box standard data (parameters) converter 20-177