Deutz — 1.2 HARDWARE REQUIREMENTS

6. OPERATOR’S MANUAL EDS (Electronic Diagnosis System) 1. GENERAL INTRODUCTION 1.2 HARDWARE REQUIREMENTS Converter Serial line K-line Control box Hardware Setup 1.2.1 INTERFACE CABLE (SERIAL) The depicted interface cable is plugged into the serial interface (COM 1 or COM 2) of the computer and connected with the corresponding connectors of the adapter cable. 1 - Plug (designation ”EIC”) for connection to the serial interface (RS 232) at the computer for diagnosis INFOCENTER. 2 - Plug (designation ”9141”) for connection to the serial interface (RS 232) at the computer for diagnosis POWERSHIFT- and POWERSHUTTLE-transmission, AGROTRONIC-hD and spring-suspended front axle.

3 - Plug for 12 V supply of the interface cable for connection to the cigar lighter. 4 - Diagnosis plug for AGROTRONIC-hD, gear box control and spring-suspended front axle, 4-pole. 5 - Diagnosis plug for INFOCENTER, 2-pole. 6 - Adapter for diagnosis POWERSHIFT transmission, old version. 20-178