Deutz — 1.2 HARDWARE REQUIREMENTS

6. OPERATOR’S MANUAL EDS (Electronic Diagnosis System) 1. GENERAL INTRODUCTION 1.2.2 ADAPTER CABLE FOR CENTRAL DIAGNOSIS INTERFACE The depicted adapter cable is plugged into the diagnosis interface in the fuse box and connected with the corresponding connectors of the PC interface cable.

8 - Central plug 14-pole for connection in the fuse box 9 - Diagnosis plug for ”Agrotronic-hD”, 4-pole 10 - Diagnosis plug for ”Infocenter”, 2-pole 11 - Diagnosis plug ”Powershift Agrotron 4.70 – 6.45”, 4-pole 12 - Diagnosis plug ”Spring-suspended front axle”, 4-pole 13 - Diagnosis plug ”Electronic motor control”, 4-pole 14 - Diagnosis plug for ”Full powershift Agrotron 160-200”, 3-pole 15 - Diagnosis connection for ”MOBI-DIG (ZF)”, 4-pole NOTE. Both free cable ends are not used. 1.2.3 SYSTEM REQUIREMENTS The applied computer (notebook, laptop or portable system) needs to fulfill the following requirements in order to install and execute EDS:

IBM compatible personal computer with at least a 80486 processor. CAUTION! For the use of SERDIA – SERvice DIAgnosis program for the electronic motor control from DEUTZ AG – a Pentium‘- processor is recommended. Main memory (RAM) at least 640 kB Disk drive 3,5” for 1,44 MB floppy disks (HD) Hard disk with at least 2,5 MB of free memory space at least one serial interface COM 1 (RS 232) Operating system MS-DOS from version 6.xx on An additional serial/k-line converter is required for the communication with the diagnosis interface (included in the scope of supply of the company Wilbдr). 20-179