Deutz — 3.2 DEST 45 PROGRAM DESCRIPTION

6. EDS (Electronic Diagnosis System) 3. POWER-SHUTTLE DIAGNOSISPROGRAMM DEST 45 Diagnosis > Plaintext data display CAUTION! After selecting the menu item ”End-of-line programming” the ignition on the vehicle needs to be switched off and on again in order to update all data in the window ”Plaintext data display”! Plain text data display opens a window in which the data are converted and displayed in their corresponding physical units. The structure and contents of the window are shown in the figure below. By pressing the key ”T” it is possible to toggle between continuous display and static display.

The current status is indicated left at the top of the window as CONT (for continuous display) resp. STAT (for static dis- play). Fig. 28 - Plaintext data display It is possible to switch between the individual windows for digital inputs, digital outputs, sensor errors and internal var- iables by means of the select fields (buttons) >, >, > and > (al- so compare ”DEST 38 program description”). The window for speeds/drive information is always visible. Possible errors are indicated in each individual window. In case of continuous display a rotating dot indicates which variable resp. which value is currently being refreshed.

Charts with descriptions about matching internal pin assignments and for the contacts of the E-box for the respective windows can be called by means of pressing the keys F3 and F4. Pressing the key ESC (or C) quits this menu item. > Digital inputs Upon selecting > a list of the digital inputs appears on the right side of the screen together with their cor- responding addresses and values. So in the continuous display mode (CONT) it is possible to check whether the re- spective signal is being transferred in to the E-box.

Tip plus Powershift plus at the gear lever Tip minus Powershift minus at the gear lever FS neutral Drive switch (power-shuttle lever) in neutral position FS forward Drive switch (power-shuttle lever) in forward position FS reverse Drive switch (power-shuttle lever) in reverse position System pressure 18 bar system pressure switch HK pedal switch Proximity switch at main clutch pedal Pin code 1 Set to value 1 if type of transmission is T7100 Pin code 2 Set to value 1 if type of transmission is T7200 Gear sync transm Starter inhibit switch at control console Starter inhibit Push-button switch at drive switch (POWER-SHUTTLE lever) 20-189