6. EDS (Electronic Diagnosis System) 3. POWER-SHUTTLE DIAGNOSISPROGRAMM DEST 45 Via the menu item ”Select output ports” it is possible to set or reset the individual digital outputs. After calling the menu item ”Select output ports” a window appears in which the data of the individual outputs of the transmission-E-box are dis- played. The outputs are indicated line by line. Column 1: In this column the components activated by the respective output are indicated. Column 2: In this column the internal addresses (pins) of the digital outputs are indicated. Column 3: This column indicates the current status of the output:
Hereby the indication ”1” signifies that the output is set and therefore a signal (voltage) is existing at the corresponding pin of the E-box. The indication ”0” signifies that the output is not set and therefore no signal is existing. Highlighted fields in different colours show to the user those outputs which are connected to the E-box and therefore are ready to be activated. Column 4: In this column the user can select one of the connected outputs by means of the cursor keys, i.e. the desired field is highlighted in a different colour. This output status can be toggled (activated resp. deactivated) by pressing the EN- TER key.
The output will be set in the E-box and subsequently be read in again by the DEST program. Due to safety reasons the changes which have been carried out will be reset to the normal state after the menu item ”Activate outputs” has been quit. Column 5: In this column the errors of the digital outputs are shown. Thereby the letters”KM”signify a short circuit to ground and ”LU” stands for a line interruption. Diagnosis > EEPROM read/write This menu item allows the user to read and edit the customer area contents of the EEPROM. On selection a window ap- pears in which the contents are shown (see figure).
The user can alter individual characters with the help of the cursor keys and confirm these changes with > (ALT + O or ENTER). Subsequent to every writing process into the EEP- ROM customer area an identification (date) is saved which can be read later on via the menu item Control > Information. This menu item can be quit by means of pressing the ESC key (or ALT + C). Fig. 33 - EEPROM read/write The first nine characters of the customer area are highlighted in a different colour. The menu item ”End-of-line program- ming” fills in the vehicle identification number into this area.
In case of storing the contents of the error memory into a file DEST 45 checks whether the first four characters of the EEP- ROM customer area correspond to a valid vehicle identification prenumber. If this is the case the vehicle identification number and the corresponding number of the electronic box will also be stored into the file. Otherwise both values cannot be stored. Due to the aforementioned reasons this area should not be edited by the user himself. Therefore, upon opening the window the cursor is located at the position on the right beside it. 20-192