6. EDS (Electronic Diagnosis System) 3. POWER-SHUTTLE DIAGNOSISPROGRAMM DEST 45 Connect the computer, boot the system and call ”Control > End-of-line programming”. The determination of the con- tact pressure is started by means of >. Further instructions can be directly taken from the > file stored in the computer. After quitting the help file the determination of the contact pressure is carried on according to the instruction. During the calibration process the pressure in the main clutch upon which frictional connection occurs is determined. Hereby the tractor moves about 0,5 m forward on ist own.
Simultaneously the E-box detects the ”speed at the output of the main clutch” and terminates the determination of the contact pressure. > Contact pressure T 7200 5,0 – 8,0 bar > Contact pressure T 7100 6,0 – 9,0 bar The determined value is stored in the transmission control unit (E-box) by means of switching the ignition off and on again and can be looked up in the plain text display under >. Leaving end-of-line programming: The end-of-line mode is quit by pressing C (or ESC). The determined values are stored in the EEPROM by means of switch- ing the ignition off and on again. 20-198