Deutz — 3.11 ERROR ANALYSIS

EDS (Electronic Diagnosis System) POWER-SHUTTLE DIAGNOSISPROGRAMM DEST 45 3.11 ERROR ANALYSIS Interchanging of electrical connectors at the transmission T-7100 L and T-7200 L Various sensors/solenoid valves/switches at the transmission are located very close to each other and are equipped with the same type of connector. At these locations the electrical mating connectors at the cable harness cannot be layed in a way which ensures that accidental interchanging may be absolutely excluded. The following consideration shows the consequences if electrical connectors are interchanged:

3.11.1 VA SOLENOID VALVE AND TEMPERATURE SENSOR T-7100 L AND T-7200 L Both elements are equipped with Jet-Tronic connectors; distance approx. 75 mm with T-7100 and 55 mm with T-7200. VA plug on temperature sensor and VA – SV ”OFF” All-wheel ”OFF” ‡ 12V voltage at temperature sensor Error code on display Electronic system shifts gear to permanent neutral Vehicle cannot be moved any more!

VA plug on temperature sensor and VA – SV ”ON” All-wheel ”ON” ‡ 0V voltage at temperature sensor Error code on display; temperature sensor defective Hard gear shifts (5V supply in electronic system is overloaded, but short circuit proof) Temperature sensor plug on VA – SV Error code on display; temperature sensor defective Hard gear shifts 3.11.2 SV DIFFERENTIAL LOCK AND SV POWER TAKE OFF CLUTCH T-7100 L AND T-7200 L Both valves are equipped with Jet-Tronic connectors; distance approx. 40 mm Plug differential lock on SV power take off valve Interchanged functions upon switch actuation in cabin Power take off stub is running upon diff.

”ON” Upon ZW clutch ”ON” and differential lock ”OFF” the differential lock is engaged. Critical driving state with regard to safety, e.g. when driving in a curve, etc. 3.11.3 SPEED SENSORS INPUT/OUTPUT WITH T-7100 L AMP superseal 3-pole connectors at both sensors, distance approx. 80 mm Plug output on input sensor and vice versa (both plugs are connected!) Upon powershift step L and H Error is not detected LS transmission in neutral Upon powershift step M Error is not detected No consequences 20-219