Deutz — 4.1 PROGRAM DESCRIPTION

EDS (Electronic Diagnosis System) DIAGNOSIS OF THE INFOCENTER 4.1.4 F3 – TEST MODE Upon pressing the key F3 the test mode appears. At the lower screen edge the test mode menu is displayed: It is possible to do the following by pressing the key: F1 Check the inputs into the INFOCENTER. F2 Set (activate) the outputs of the INFOCENTER. F3 Check the LCDs (upon INFOCENTER 2 and 3). F5 Check the analog inputs into the INFOCENTER. F6 Check the pointer instruments. END Leave the test mode; subsequently the main menu appears. TEST MODE > F1 CHECK INPUTS Upon pressing the key F1 the following window appears: (The representation shows the example of an INFOCENTER 2 in the AGROTRON 150.

The ignition is switched ON.) Fig. 56 - Check inputs Check inputs > parking brake The signal input of the hand brake control switch at plug X 130, pin 8 of the INFOCENTER (only for INFOCENTER 3) is tested. - Locking brake actuated: Indication hand brake ON - Locking brake released: Indication hand brake OFF Check inputs > Air filter The signal input of the negative pressure switch air filter at plug X 131, pin 8 of the INFO-CENTER (only for INFOCENTER 3) is tested. - Ignition on, indication air filter OFF - Start engine, connect cable of negative pressure switch, indication air filter ON 20-225