EDS (Electronic Diagnosis System) DIAGNOSIS OF THE INFOCENTER Check inputs > Transm.fl.press. The signal input of the system pressure switch at plug X 130, pin 7 of the INFOCENTER (only for INFOCENTER 3) is test- ed. - Engine off, ignition on: Indication transmission oil pressure ON - Start engine: Indication transmission oil pressureOFF Check inputs > air pressure The signal input of the pressure transducer at plug X 131, pin 17 of the INFOCENTER (only for INFOCENTER 3) is tested. Engine off, ignition on, indication pressurized air gauge > 7 bar: - Indication pressurized air off Ignition on, reduce boiler pressure to - Indication pressurized air ON Check inputs > eng.
oil level This function cannot be tested as it is not realized (transmitter not existing). Check inputs > Preheat The signal input of the preheating time control unit at plug X 131, pin 19 of the INFOCENTER (only for INFOCENTER 3) is tested. - Ignition ON, during preheating process indication ON, subsequently indication OFF. Check inputs > Front PTO The signal input of the switch front power take-off at plug X 131, pin 10 of the INFOCENTER is tested.
- Ignition ON, indication FRONT power take-off OFF - Start engine, front power take-off ON, indication front power take-off ON Check inputs > Rear PTO The signal input of the switch rear power take-off at plug X 131, pin 11 of the INFOCENTER is tested. - Ignition ON, indication rear power take-off OFF - Start engine, rear power take-off ON, indication rear power take-off ON Check inputs > road lights The signal input of the switch dipped beam at plug X 130, pin 4 of the INFOCENTER is tested .
- Ignition ON, switch dipped beam OFF, indication dipped beam OFF - Ignition ON, switch dipped beam ON, indication dipped beam ON Check inputs > turn signal 2 The signal input of the multifunctional switch at plug X 131, pin 2 of the INFOCENTER is tested. With connected trailer the indication changes between flashing indicator 2 on and flashing indicator 2 off in the rhythm of the flashing. Check inputs > turn signal The signal input of the multifunctional switch at plug X 131, pin 4 of the INFOCENTER is tested. - Ignition on, flashing indicator not actuated indication flashing indicator off - Ignition on, actuate flashing indicator indication changes between flashing indicator on and off.
Check inputs > high beam The signal input of the multifunctional switch at plug X 131, pin 16 of the INFOCENTER is tested. - Ignition ON, Indication: Main beam OFF - Switch ON main beam (flash light) Indication: Main beam ON Press the ENTER key to return to the TEST MODE. TEST MODE > F2 SET OUTPUTS Upon pressing the key F2 the following window appears: 20-226