Deutz — 1.3 SWITCHING ON AND INSTALLING THE SOFTWARE

SERDIA SETUP AND COMMUNICATIONS 1.3 SWITCHING ON AND INSTALLING THE SOFTWARE 1.3.1 INSTALLING MS WINDOWS If MS Windows is not already installed on your hard disk, it must first be installed following the installation instructions sup- plied with MS Windows 3.1, 95, 98 o 2000. 1.3.2 INSTALLING SERDIA FROM DISKETTES To run the SERDIA software, an interface with a connection to an engine control module is required. If this interface is not present, SERDIA can still be installed, but will only run in Off-line mode. The software limitations imposed by off-line mode are described in Chapter "Off-line mode". Installation with Windows 3.1, 3.11: Start Windows.

Insert SERDIA Installation diskette 1 in the disk drive (Drive A). Open "File Manager". Select disk drive A. Double-click on the "install.exe“ file to start installation. Follow the instructions appearing on the screen. When finished, remove Installation diskette 2 from the disk drive and store in a safe place together with diskette 1. After the computer is re-started, the SERDIA program group window opens. Double-click on the "Service diagnosis“ program group to start. Installation bei Windows 95, 98: Start Windows. Insert SERDIA Installation diskette 1 in the disk drive (Drive A) einlegen. Open "Windows Explorer". Select disk drive A.

Double-click on the "install.exe“ file to start installation. The Installation window opens: •The name of the target directory should indicate the SERDIA Version number, for example "serdia35“. Follow the instructions appearing on the screen. (If installing with Windows 98, select Windows 95 as the operating system) When finished, remove Installation diskette 2 from the disk drive and store in a safe place together with diskette 1. After the computer is re-started, the SERDIA program group window opens. Double-click on the "Service diagnosis“ program group to start. 20-259