Deutz — 1.3 SWITCHING ON AND INSTALLING THE SOFTWARE

SERDIA SETUP AND COMMUNICATIONS Special characteristic of Notebooks with Windows 98: The ACPI entry (Advanced Configuration and Power Interface) may not appear under "Start\Settings\Control Panel\Sys- tem\Device Manager\System components. In this case, follow the instructions in the "Readme.txt" file ("Windows 98" section) included on the SERDIA Installation disk. Proceed as follows: Check whether ACPI is enabled. If there are ACPI entries, switch off ACPI using the "disacpi.reg“ file. These files are in the SERDIA working directory. (ACPI can be switched on again using the "enacpi.reg“ file). Run the new hardware recognition program:

Start\Settings\Control Panel\Add New Hardware\Next\ Search for new hardware. (The Installation CD may be required for Windows 98). Re-start the computer. Installation with Windows 2000: To install under Windows 2000, the 32Bit Version of SERDIA is required. This should be available from May 2002, and will be indicated in the service announcements. 1.3.3 INSTALLING SERDIA FROM THE SERPIC CD Start Windows. Insert the SERPIC CD in the CD drive. Open "Windows Explorer". Select the CD drive. Open the SERDIA directory. Open the "Disk1“ directory Double-click on the "install.exe“ file to start installation. The Installation window opens:

The name of the target directory should indicate the SERDIA Version number, for example "serdia35“. Follow the instructions appearing on the screen. (If installing with Windows 98, select Windows 95 as the operating system) Remove the CD from the drive and store in a safe place. After the computer is re-started, the SERDIA program group window opens. Double-click on the "Service diagnosis“ program group to start. 1.3.4 USER LEVEL, ACCESS RIGHTS DEUTZ Service has defined four different user levels for the SERDIA software (I, II, III, IIIa), which are pre-set in the interface.

The reason for the four different levels is to prevent unauthorised persons from accessing particular parameter settings (in the same way as the seals at injector pumps). The use of access rights means access is only allowed to those parameters and fields authorised for a particular user level. 20-260