SERDIA MEASURED VALUES 3.1.1 MEASURED VALUE SELECTION The list of available measured values is displayed. The measured values to be displayed can be selected from this list. An individual measured value is selected by clicking on the associated check box. If a graphical display is required, not more than 5 measured values can be selected (see 3.1.2 Graphics). The four buttons on the right of the list can be used to activate and de-activate a collection of measured values. These have the following functions: Save : The displayed selection of measured values is saved to a file. Load : The selected measured values are loaded from a file. Delete selection :
All measured values are de-activated for display. Select all : All measured values are activated for display. OK : Return to the display of the current measured values. The changes made to the selection of measured values are saved. Cancel : Return to the display of the current measured values. The changes made to the selection of measured values are cancelled. The following tables give an overview of the measured values which can be displayed. For some parameters, a config- uration operation is also required (see Chapter 4 Parameters); this enables specific measuring points to be assigned to the inputs and outputs of the EMR1/EMR2 ("Configuration", "Page 11:
assignment inputs/measured values“ and "Page 13: assignment outputs/measured values"). The values required for parameter configuration are shown in the tables. The as- signment can be subsequently checked in the "Measured values" menu, with the window "Display of inputs and outputs" (see 3.4 Input/output assignment). 3.1.1.1 MEASUED VALUES EMR1 MEASURED VALUE SELECTION 20-272 Name of measuring point Description Associated RAM value Battery voltage Battery voltage – Engine speed Speed 1 (camshaft) Speed 2 (crankshaft) 2000 2002 Control rod position Control rod position (M9)Coolant temperature Coolant temperature 3551 Fuel injection quantity Fuel injection quantity