Deutz — 5.2 ERROR TABLE

SERDIA EMR2 ERROR TABLE 20-294 Check cable of digital output (cable break or short circuit). Check CAN connection, terminating resistor (see Chapter 12.4). Check control unit. Switch ignition off and on again. Check again. If faulty inform DEUTZ Service Note values of parameters (3895 and 3896). Switch ignition off and on again. Check again. If faulty inform DEUTZ Service. Switch ignition off and on again. Check again. If faulty inform DEUTZ Service. Check voltage supply. Switch ignition off and on again. Check again. If faulty inform DEUTZ Service Switch ignition off and on again. Check again. If faulty inform DEUTZ Service. Driver level is switched off. Fault message. Applicationdependent.

Emergency switchoff. engine cannot be started. Fault message (disappears when power again in the normal range). Fault message (disappears when power again in the normal range). Auxiliary value 5 V Fault message (disappears when power again in the normal range). Fault message (disappears when power again in normal range). Atmospheric pressure monitoring function de-activated. Fault (short circuit /cable break) at digital output. CAN-controller for CAN-bus is faulty. Fault removal despite reinitialising continuously not possible Overflow nel buffer di ricezione oppure non è possibile un invio tramite bus. Fault in parameter programming in the governor fixed value memory.

Constant monitoring of program memory shows error (socalled “Flash-test”). Constant monitoring of working memory shows error. Power supply for actuator not in the permissible range. Reference voltage for actuator not in the permissible range. Internal temperature for control unit not in permissible range. Atmospheric pressure not in permissible range.

1 2 1 2 2 1 1 1 2 2 6 6 6 6 6 7 8 9 8 9 2 2 2 2 2 2 2 2 2 2 Digital output 3 (Switch-off solenoid, pin M 2) Digital output 6, pin M 7 Excess voltage switch-off solenoid Error Hand Setp 1 Error CAN Setp 1 CAN-Bus controller CAN interface SAE J 1939 Parameter programming (write EEPROM) Cyclic program test Cyclic RAM test Power supply (Actuator) Reference voltage 1 Reference voltage 2 Reference voltage 4 Internal temperature Atmospheric pressure 60 62 63 67 68 70 71 76 77 78 80 83 84 85 86 87 Hardware inputs/outputs Communication Memory Control unit hardware