SERDIA WHAT TO DO IF...? METHOD 2.: Every EMR1 has a specific engine data set, which is kept in a central computer at DEUTZ AG when the engine is delivered. Any modifications to EMR1 configuration settings must be reported back to DEUTZ AG. When a new control unit is or- dered, it is programmed with a data set available to DEUTZ AG under the corresponding engine number. Therefore, if setting corrections to the engine are not reported back to DEUTZ AG, these may not be taken into account when programming a new control unit. Switch off the ignition/supply voltage. Remove both connectors from the old control unit. Connect the control unit with the engine and vehicle connectors (both 25-pin).
Switch on ignition/supply voltage. Open the SERDIA program. In the "Error memory" menu, clear the error memory. Start the engine and check that it runs satisfactorily. 8.2.9 ERROR READING THE CONFIGURATION DATA This error message appears if SERDIA is unable to read the Hex file. The file possibly contains Umlauts (д, ц, ь), or other special characters not understood by SERDIA 20-315