Deutz — Removal

4WD PROPELLER SHAFT 4WD PROPELLER SHAFT Version without front suspension Removal Remove the key from the ignition and apply the park- ing brake. 1 - Using suitable lifting equipment, raise the front of the tractor by about 10-12 cm (4-5 in.). 2 - Position a jack “ A “capable of supporting the tractor's weight under the front carrier. A F0044630 3 - Remove the bolts (1) and remove the locating and retaining washers (2) of the tank (3). Mark the washers so as to avoid error when re- fitting the tank. Note the position of the hole “ B ” as the tank is levelled by rotating the front washer .

B 2 1 3 F0018636 4 - Label and disconnect the fuel suction pipe (4) and return pipe (5) and the level indicator connector (6). The fuel suction and return pipes are marked on the side of the connection fittings. 4 5 6 F0078440 5 - Move the fuel tank 8–10 cm towards the outside. Loosen and remove the bolt (7) securing the spacer (8) and the lower guard. 8 7 F0078450 30-66