POWER STEERING UNIT POWER STEERING UNIT Testing 1 1 - Disconnect a steering pipe (1) and connect a fitting B ” with a 400 bar pressure gauge “ A 2 - Start the engine and turn the wheel back and forth be- tween the full lock positions to eliminate all air from the system. 3 - Force the steering to full lock on the side to which the pressure gauge is connected and read off the maxi- mum continuous pressure on the gauge “ A Maximum permissible pressure: 191–198 bar (2270–2871 psi) A B F0044770 4 - If the pressure reading differs from that specified, ad- just the maximum pressure valve (2) of the power steering unit (3). Adjustment 1 - Remove the plug (4).
2 - Loosen off the screw (5) using a 4 mm hex socket wrench. To INCREASE the pressure, turn the screw CLOCKWISE. To REDUCE the pressure, turn the screw COUNTER-CLOCKWISE 3 - Refit the plug (4), checking the gasket (6) is in its seat- ing. Plug : 50±10 Nm (36.8±7.4 lb.ft.) 30-77 3 2 6 4 5 F0012581 F0012581