FRONT SUSPENSION CYLINDERS FRONT SUSPENSION CYLINDERS (Where fitted) Removal All operations must be carried out with the parking brakes applied. 1 - Operate the button in the cab to activate the front sus- pension, fully extending the suspension cylinders. 1 2 - Position and tighten a jack “ A ” under the front carrier (1). A F0044880 3 - Deactivate the suspension so that the cylinders are fully retracted. 4 - Support the swinging support (2) on a stand “ B ” that can be lowered through10-12 cm (4- 5 in.) and switch off the engine. 2 5 - Remove the front wheels. (For details, see "FRONT WHEELS").
B F0078630 Discharge the residual pressure from the system by unscrewing the valve (3) about two full turns Wait a few minutes after discharging the pres- sure, then re-close the valve. 6 - Remove the reinforcing side members. (For details, see "REINFORCING SIDE MEMBERS"). 3 3 F0078490 7 - Disconnect the pipes (5), (6) from the left cylinder (4). First loosen the fittings by a few turns, then, be- fore disconnecting the pipes, push them to de- tach them from the couplers and release any residual pressure. Plug the ends of the pipes to prevent the entry of contaminants. 5 4 8 - Unplug the steering sensor connector (7) 6 7 F0044900 30-106