ENGINE MAINTENANCE - Maintenance Procedures Centrifugal Bypass Oil Filter Installation Procedure to intall the centrifugal bypass oil filter on PACCAR MX-13 engines. 5. Position the screw cap carefully onto the oil module. 6. Tighten the screw cap by hand until it reaches the end position. 7. Tighten the screw cap to 30 lb-ft (40 N·m). Use a hexagonal socket, or box wrench, to avoid damaging the oil filter cap. Then remove the oil filter cartridge from the screw cap. 3. Remove the O-ring from the screw cap. 2 Follow the steps below to install the centrifugal bypass oil filter: WARNING Centrifugal Bypass Oil Filter Installation Lubricating oil can cause skin irritation or skin injury.
To prevent skin injury, avoid unnecessary contact with the lu- bricating oil. Wear protective clothing, eye wear and gloves when handling lubricating oil. Failure to comply may result in personal injury. Full-flow Oil Filter Removal Procedure for removing full-flow oil filter on PACCAR MX-13 engines. 1 2 Full-flow Oil Filter Module Full-flow Oil Filter Installation Procedure for installing full-flow oil filter on PACCAR MX-13 engines. 3 1. Lightly lubricate the new O-ring (1) with engine oil. 2. Fit the new O-ring (1) onto the cap (2). 3. Mount the centrifugal filter (3) with its top side in the bearing of the screw cap (2). 4. Check to ensure the centrifugal filter (3) can rotate freely.
Use the following procedure to install full- flow oil filters. 1. Lightly oil the new O-ring. 2. Install the new O-ring onto the screw cap. 3. Install the screw cap, with the oil filter cartridge, onto the filter housing. Tighten the screw cap to 30 lb-ft (40 N·m). Use a hexagonal socket to avoid damaging the oil filter cap. 1. Unscrew the cap a few turns and drain the filter housing. Use a hexagonal socket, or box wrench, to avoid damaging the oil filter cap. 2. Remove the cap, with the oil filter cartridge, from the filter housing. 54 Y53-1181-1K1 (08/2018)