Manual Transmissions and Clutch Eaton® Fuller® Transmission Operation Tips Eaton Fuller Splitter and Range-Shift Transmissions Refer to the Eaton website ( www.roadranger.com ) for additional information. Combination splitter and range-shift transmissions allow the choice of two splitter ratios in each gear, as well as the additional ratios provided by a low range and a high range. Follow these important operation principles: For all conditions, use the highest gear that is still low enough to start the vehicle moving with the engine at or near idle speed, and without slipping the clutch excessively. General Information, Range-Shift Transmissions IMPORTANT:
Not all ratios are used in each range, and the shift patterns vary between transmissions. Read the shift pattern decal on the dash for the operating instructions for the transmission installed in your vehicle. When operating on-highway with no load or under ideal conditions, use 1st gear to start the vehicle moving forward. When operating off-road or under adverse con- ditions, use LOW gear to start the vehicle mov- ing forward. The range-preselection lever selects the low or high range for each transmission ratio. It is used once during an upshift sequence and once during a down- shift sequence.
Use the clutch brake to stop gear rotation when shifting into LOW or reverse while the vehicle is stationary. The clutch brake is actu- ated by depressing the clutch pedal all the way to the floor. To operate a range-shift transmission, move the gear shift lever through all the low-range gear positions and then pull the range-preselection lever up to move into the high-range ratios. Partially disengage the clutch to break engine torque during normal gear shifts. Double-clutch between all upshifts and down- shifts that require movement of the shift knob. Splitting of gears does not require movement of the shift knob. IMPORTANT: Always preselect range shifts when upshifting or downshifting.
Preselection requires that the range lever be moved to the necessary position before starting to shift. Pre- selecting range shifts prevents damage to the transmission and provides for smoother shifts. Never push the range-preselection lever down into low range while operating in high range, except when downshifting from 5th gear to 4th gear. General Information, Splitter Control Do not shift from high range to low range at high vehicle speeds. Dependent on the transmission model, some ratios can be split using the splitter-control button (located on the side of the gear shift lever). Never make a range shift or a splitter shift while the vehicle is in reverse. IMPORTANT:
Always preselect splitter shifts. Preselection requires that the splitter-control button be moved to the necessary position be- fore starting to shift. Preselecting splitter shifts allows for smoother and faster shifting. Com- plete the shift immediately after preselecting the split to avoid unnecessary wear on transmission components. Never move the range-preselection lever with the transmission in neutral while the vehicle is moving. Skip ratios while shifting only when operating conditions permit, depending on the load, grade, and road speed. Never coast with the transmission in neutral. 14.1