Western Star — Western Star (EN)

Manual Transmissions and Clutch Eaton Fuller 13-Speed Splitter and Range-Shift Transmissions 5. Upshift from LOW (or 1st gear) through 4th gear, double-clutching when moving the gear shift lever, and accelerating to 80 percent of engine governed speed. Eaton Fuller 13-speed transmissions have thirteen forward speeds and two reverse speeds. Each trans- mission consists of a 5-speed front section and a 3-speed auxiliary section. The auxiliary section con- tains low- and high-range ratios, plus a splitter gear. See Fig. 14.1 for the shift pattern. 6. While in 4th gear, pull the range-preselection lever up into high range and move the splitter- control button to the low (rearward) position.

Double-clutch into 5th gear, engage the clutch, and accelerate. Hi R 1 3 Dir OD 5 5 Dir OD 7 7 1 7. Upshift progressively through the high range gears. Lo To shift from 5th direct to 5th overdrive (or 5th underdrive to 5th direct on RT model transmis- sions), move the splitter-control button to the high position, then immediately release the ac- celerator. Press and release the clutch pedal, then, accelerate again. N A B 2 4 LOW Dir OD Dir OD 6 6 8 8 Continue upshifting through the shift pattern. Double-clutch when moving the gear shift lever (6th to 7th, etc.); single-clutch during split shifts (6th direct to 6th overdrive, etc.). 03/13/96 f260044a C D A. High Range B. Low Range C.

High (forward) D. Low (rearward) 1. Splitter Control Button Downshifting Fig. 14.1, Eaton Fuller 13-Speed Transmission Shift Pattern IMPORTANT: Never use the clutch brake when downshifting, or as a brake to slow the vehicle. LOW gear is used only as a starting gear; it is never used with the transmission in high range. The other four ratios are used once in the low range and once again in the high range. 1. To downshift from 8th overdrive to 8th direct (or 8th direct to 8th underdrive on RT model trans- missions), move the splitter-control button to the low position, then immediately release the accel- erator.

Press and release the clutch pedal, then accelerate once the transmission has shifted. High range gear ratios can be split by using the splitter-control button with the underdrive ratio (RT models), or overdrive ratio (RTO models). Low range gear ratios cannot be split. 2. Start the downshift from 8th direct to 7th over- drive by moving the splitter-control button to the high position, then double-clutch into 7th gear. Upshifting 1. Put the transmission in neutral. Start the engine and bring the air system pressure up to 100 to 120 psi (689 to 827 kPa). 3.

Downshift progressively through each of the high range gears, alternating the procedures in steps 1 and 2 above until reaching 5th direct. 2. Position the range-preselection lever down, in low range. 4. When in 5th direct and ready for the downshift to 4th, push the range-preselection lever down and move the splitter-control button to the high posi- tion. Double-clutch into 4th gear, engage the clutch, and accelerate. 3. Make sure the splitter-control button is in the low (rearward) position. See Fig. 14.1 . 4. To start the vehicle moving, press the clutch pedal to the floor, shift into LOW or 1st gear, then engage the clutch with the engine at or near idle speed.

Accelerate to 80 percent of engine governed speed. 5. Continue downshifting from 4th gear to 1st gear, as conditions require. 14.2