Western Star — Western Star (EN)

Manual Transmissions and Clutch A B 1 Never move the deep reduction button from a rearward position to a forward position when the transmission is in high range. 1 4 5 8 1 3 5 7 C Deep reduction gears are best suited for heavy loads and steep inclines. N N 6 7 3 2 D 2 6 8 4 Upshifting Deep Reduction Transmissions E F There are several patterns of upshifting, depending on the vehicle load and the road conditions. See Table 14.1 for suggested shifting sequences. 03/13/96 f260026a A. All RTO Transmissions B. All RT Transmissions C. High Range D. Low Range E. Deep Reduction IN (forward) F. Deep Reduction OUT (rearward) 1.

Deep Reduction Button The following instructions are recommended for start- ing a loaded vehicle moving under adverse condi- tions. 1. Put the transmission in neutral. Start the engine, and bring the vehicle air system pressure up to 100 to 120 psi (689 to 827 kPa). Fig. 14.4, Eaton Fuller 10-Speed Deep Reduction Shift Patterns 2. Position the range preselection lever down, into low range. Eaton Fuller 15-speed deep reduction transmissions have a 5-speed front section, and a 2-speed auxiliary section. They also have five additional deep reduc- tion ratios. The 5-speed front section and the low and high range sections provide ten evenly and pro- gressively spaced forward speeds.

The five deep re- duction ratios are also evenly and progressively spaced; however, they do overlap the low range ra- tios, and should be used only when operating under adverse conditions. See Fig. 14.5 for the shift pat- terns, noting that the 4th/9th, and the 5th/10th shift positions in RT (direct ratio) transmissions are di- rectly opposite to the RTO (overdrive ratio) positions. 3. Move the deep reduction button to the forward position, to engage the deep reduction gears. 4.

Depress the clutch pedal to the floor; shift into low-low gear (10-speed transmissions) or 1st gear of deep reduction (15-speed transmissions); then engage the clutch, with the engine at or near idle speed, to start the vehicle moving. Ac- celerate to 80 percent of engine governed speed. 5. For 10-speed transmissions: When ready for the next upshift, move the deep reduction button rearward, then momentarily de- press the clutch pedal. Do not move the shift lever. Use the following tips when shifting: Use the clutch brake to stop gear rotation when shifting into low-low, low-1st (whichever is used as a starting ratio) or reverse, when the vehicle is stationary. For 15-speed transmissions:

For normal upshifts and downshifts, only a par- tial disengagement of the clutch is necessary to break engine torque. Shift upward from 1st gear of deep reduction to 5th gear of deep reduction, double-clutching be- tween shifts and accelerating to 80 percent of engine governed speed. See Table 14.1 . When making the shift from a deep reduction ratio to a low range ratio, move the deep re- duction button from a forward position to a rearward position, then complete the shift im- mediately. When ready for the next upshift, move the deep reduction button rearward, then double-clutch into 4th gear. 14.5