Manual Transmissions and Clutch through into 4th gear, engage the clutch, and accelerate. 4. Upshift progressively from 1st gear through 5th gear, double-clutching when moving the gear shift lever. 5. Continue downshifting from 4th overdrive to 4th direct, then 4th direct to 3rd overdrive, etc. Double-clutch when moving the gear shift lever (4th to 3th, etc.); single-clutch during split shifts (4th direct to 3rd overdrive, etc.). 5. When in 5th gear and ready to move to 6th gear, pull the range-preselection lever up into the high range. Double-clutch into 6th gear, engage the clutch, and accelerate. NOTE:
If after attempting to shift into the high range the transmission remains in neutral, the range synchronizer protection device may be activated. Move the gear shift lever to neutral to allow the range shift to complete, then shift back into gear. Eaton Fuller 10-Speed Range-Shift Transmissions Eaton Fuller 10-speed transmissions have ten selec- tive, evenly-spaced forward ratios. Each transmission consists of a 5-speed front section, and a 2-speed auxiliary section. The ten forward speeds are ob- tained by twice using a 5-speed shift pattern: the first time in low range, the second time in high range. See Fig.
14.3 for the shift patterns, noting that the 4th/9th and the 5th/10th shift positions in the RT (di- rect ratio) transmissions are directly opposite in the RTO (overdrive ratio) transmissions. 6. Upshift progressively through the high range gears, double-clutching when moving the gear shift lever and accelerating to 80 percent of en- gine governed speed. Downshifting A B IMPORTANT: Never use the clutch brake when downshifting, or as a brake to slow the vehicle. Lo R Hi R Hi 7 2 9 4 7 2 10 5 1. Downshift progressively through each of the high range gears, double-clutching between shifts. C Lo N N 2.
When in 5th gear and ready to move to 4th gear, push the range-preselection lever down into the low range. Double-clutch into 4th gear, engage the clutch, and accelerate. 6 1 8 3 10 5 D 6 1 8 3 9 4 03/13/96 f260043a 3. Downshift progressively through the low range gears, double-clutching when moving the gear shift lever, as conditions require. A. RT Transmissions B. RTO Transmissions C. High Range D. Low Range Fig. 14.3, Eaton Fuller 10-Speed RT and RTO Transmissions Shift Patterns Eaton Fuller Deep Reduction Transmissions General Information Upshifting 1. Put the transmission in neutral. Start the engine and bring the air system pressure up to 100 to 120 psi (689 to 827 kPa).
Eaton Fuller 10-speed deep reduction transmissions have a 5-speed front section, and a 2-speed auxiliary section, with a deep reduction gear. The low-low, deep reduction gear is used only when operating under adverse conditions. Low gear in the front sec- tion is used only for rough, off-highway conditions, as a starting ratio. The remaining four forward positions are used once in the low range and once in the high range. See Fig. 14.4 for the shift pattern, noting that the 3rd/7th and 4th/8th shift positions in RT-LL trans- missions are opposite of the RTO-LL transmissions. 2. Position the range-preselection lever down, in low range. 3.
To start the vehicle moving, press the clutch pedal to the floor; shift into 1st gear, then engage the clutch with the engine at or near idle speed. Accelerate to 80 percent of engine governed speed. 14.4