Western Star — Western Star (EN)

Manual Transmissions and Clutch 7. While in the top gear of the low-range shift pat- tern, flip the range preselection lever up. Double- clutch into the bottom gear in high range (see Table 14.1 ). NOTICE Do not allow the clutch to slip longer than two seconds. Clutch slippage for longer than two seconds may severely damage the clutch disc, pressure plate, or flywheel. Damage caused by clutch slippage due to improper break-in is not warrantable. 8. With the transmission in high range, shift pro- gressively upward through each of the high range gears (see Table 14.1 ), double-clutching between shifts.

Downshifting Deep Reduction Transmissions During initial operation of a new vehicle or a vehicle with a new clutch, check for clutch slippage during acceleration. If the clutch slips, decelerate until the clutch does not slip. Allow the clutch to cool 15 to 30 seconds, then gradually accelerate again. If the clutch continues to slip, repeat the procedure as many as five times. If the clutch slips after five at- tempts, stop the vehicle and allow the clutch to cool for at least one hour. Notify your Western Star dealer of the problem. 1. With the transmission in high range, shift pro- gressively downward to the bottom gear in high range, double-clutching between shifts. 2.

When in the bottom gear of the high-range shift pattern, push the range preselection lever down. Double-clutch into the top gear of the low-range shift pattern. IMPORTANT: Never move the deep reduction button to a forward position when the transmis- sion is in high range. Moving the Vehicle in the Proper Gear An empty vehicle can be started in a higher gear than can a partially- or fully-loaded vehicle. Select the gear combination that allows the vehicle to start moving with an idling engine or, if necessary, just enough throttle to prevent stalling the engine. 3. With the transmission in low range, downshift through the low range gears, as conditions re- quire.

Gear Shifting Techniques Clutch Clutch General Information Upshift into a higher gear only when the vehicle speed allows the transmission input shaft speed to match the flywheel speed when engaging the clutch. This technique results in the smallest speed differ- ence between the clutch disc and the flywheel, and causes the least heat and wear on the clutch assem- bly. When downshifting, increase the input shaft speed to match the flywheel by slightly revving the engine. To ensure long service life of the clutch, start in the right gear, be alert to clutch malfunctions, and know when to adjust the clutch. Typical operation will not break down the clutch fric- tion surfaces.

Heat and wear are almost nonexistent when a clutch is fully engaged. However, during the moment of engagement, when the clutch is picking up the load, considerable heat is generated. If a clutch slips excessively, high temperatures develop quickly between the flywheel, driven discs, and pres- sure plates. An improperly adjusted or slipping clutch can generate temperatures high enough to destroy the clutch. Vehicle Loading Clutches are designed for specific vehicle applica- tions and loads. NOTICE Exceeding vehicle load limits can result in dam- age to the clutch and the entire powertrain.

Clutch Operation Clutch Break-In The clutch may slip for a short time while the friction surfaces break-in on a new or newly-installed clutch. 14.7