Western Star — Western Star (EN)

Manual Transmissions and Clutch Clutch Brake the clutch pedal will also put a constant thrust load on the release bearing, thinning the bearing lubricant and increasing the wear on the bearing. Apply the clutch brake by depressing the clutch pedal all the way to the floor plate. The last part of pedal travel will compress the clutch brake plates together, stopping the transmission input shaft. The clutch brake stops the transmission gears from rotat- ing in order to quickly engage a transmission gear after idling in neutral. Holding the Vehicle On an Incline Always use the vehicle service brakes to prevent the vehicle from rolling backwards while stopped on a hill.

Slipping the clutch on a hill to maintain vehicle position will quickly damage the clutch assembly. NOTICE Coasting Never apply the clutch brake when making down- shifts or upshifts. If the clutch brake is applied when the vehicle is moving, the clutch brake will try to stop or decelerate the vehicle, causing rapid wear of the clutch brake friction discs. Con- siderable heat will be generated, causing damage to the release bearings and the transmission front bearings. Coasting with the clutch pedal depressed and the transmission in a low gear can cause high driven disc speed. The clutch speed can be much higher under these conditions than when the engine is driv- ing the clutch.

This condition creates a hazardous situation due to the lack of vehicle control and due to the high clutch disc speed. Engaging the clutch under these conditions can cause component dam- age because of the shock loads to the clutch and drivetrain. Using the Clutch Use the clutch pedal only when starting the engine, launching the vehicle from a stop, or shifting. To launch a stationary vehicle, depress the clutch pedal all the way to the floor plate (see Clutch Brake above) and shift from neutral to a low gear. Slowly raise your foot until the clutch starts to engage.

In this position the clutch is starting to connect the transmission input shaft to the flywheel and is caus- ing the most heat and wear. Slightly increase the en- gine speed and smoothly allow the clutch pedal to return to the rest position. Do not allow the clutch to remain in the partially-engaged position any longer than necessary to obtain a smooth start. WARNING Always shift into the gear that is correct for the traveling speed of the vehicle and engage the clutch. Coasting with the clutch disengaged can prevent engagement of the correct transmission gear which can cause loss of vehicle control, possibly resulting in personal injury or property damage.

High clutch disc speeds while coasting can also cause the clutch facing to be thrown off the disc. Flying debris from the clutch can cause injury to persons in the cab. Double-clutch to shift gears while the vehicle is mov- ing. Depress the clutch pedal most of the way in, but not all the way to the floor plate. Depressing the clutch pedal to the floor plate will engage the clutch brake. Shift the transmission into neutral and fully release the clutch pedal. When upshifting, wait for the engine speed to decrease to the road speed. When downshifting, increase the engine speed to match the road speed. Fully release the clutch pedal after completing the shift.

Clutch Maintenance Checking the Clutch Adjustment Report erratic clutch operation as soon as possible to give maintenance personnel a chance to inspect, lu- bricate, and adjust the clutch components. Notice any gradual decrease in the distance the clutch pedal moves before resistance is felt. NOTICE NOTICE Riding the clutch while driving is damaging to the clutch because partial clutch engagement causes slippage and heat. Resting your foot on Operating the vehicle with incorrect free pedal could result in clutch damage. 14.8