Western Star — Western Star (EN)

Automated and Automatic Transmissions Eaton® Fuller® Automated Transmissions Refer to the Eaton website ( www.roadranger.com ) for additional information. General Information, Automated Transmissions The Eaton Fuller UltraShift is a heavy-duty fully auto- mated transmission. The UltraShift uses a dry clutch system, so no clutch pedal is required to shift gears. The Eaton Fuller AutoShift transmission requires the driver to use the clutch to start and stop the vehicle. However, the driver does not need to use the clutch to shift gears. The Eaton Fuller automated transmissions use a shift selection module located on the dash control panel. See Fig. 15.1 .

Shifts can be made automatically, or manually using the shift selection module. The current gear is displayed on the indicator shown in Fig. 15.2 . At the start of a shift, the current gear continues to display until the transmission has been pulled into neutral. As the transmission is synchroniz- ing for the new (target) gear, the gear indicator flashes the number of the target gear. When the shift is complete, the gear indicator displays the new gear, without flashing. 07/20/2011 f611129 1. Upshift/Downshift Buttons 2. Service Needed Indicator 3. PTO Activation Button 4. Reverse Mode Button 5. Neutral Button 6. Drive Mode Button 7. Manual Mode Selector 8. Low Mode Button Fig.

15.1, Shift Selection Module, UltraShift and AutoShift Transmissions Automated Transmission Operation Modes The shift selection module controls the driving mode, which includes drive, manual, reverse, or low. IMPORTANT: In all modes but low, it is possible to shift manually by pressing the upshift or downshift selectors as needed. When the en- gine speed is within 75 rpm of the load-based shift point for an automatic shift, the transmis- sion will advance the shift. Drive Mode Press the drive mode button (D) on the shift selec- tion module to put the transmission in drive mode. 10/13/2003 f610680 NOTE: The gear indicator displays the current gear. In this example, it displays first gear.

In drive mode, upshifts and downshifts are made by the transmission without driver intervention. The transmission will shift automatically when the driver Fig. 15.2, Gear Indicator 15.1 3 2 1 PTO R N SERVICE D MANUAL SHIFT LOW EATON FULLER TRANSMISSIONS 4 5 6 7 8