Western Star — Western Star (EN)

Automated and Automatic Transmissions presses the drive mode button (D) and depresses the accelerator pedal. Reverse Mode If driving conditions require, it is still possible to re- quest a manual shift. The transmission will make the shift if the engine speed is within 75 rpm of the load- based shift point for that gear. To put the transmission in reverse, press the reverse mode button on the shift selection module. The UltraShift transmission has two reverse gears: reverse low and reverse high. The AutoShift trans- mission may have multiple reverse gears. To shift manually between the reverse gears, press the up- shift or downshift arrow button until the desired re- verse gear is displayed.

If the vehicle is stopped while in drive mode, the upshift/downshift buttons can be used to change the starting gear. This selection becomes the default starting gear until it is changed by the driver again, or the vehicle is shut down. Reverse low is the default reverse gear. When re- verse low is selected, the letter R displays on the gear indicator. See Fig. 15.3 . When reverse high is selected, the letter H is displayed. The transmission controller adapts to the working conditions of each vehicle and its driver. After power-up or a load change, it needs to learn the new conditions. While learning, it may hold a gear too long before upshifting. If this occurs, start the upshift manually.

It may take three or four shifts before the transmission succeeds in learning the new load- based shift points, but after that it will handle the shifting automatically. Automatic skip shifts may occur in drive mode if con- ditions are appropriate. Manual Mode In manual mode, upshifts and downshifts are made by the driver. This allows the driver to respond to a wide range of driving conditions, such as blind cor- ners, tight curves, and steep hills. 10/14/2003 f610681 To change to manual mode, press the manual mode button (MANUAL) on the shift selection module.

If manual mode is selected while the vehicle is moving, the current gear will be maintained until the driver requests a shift using the proper upshift/downshift arrow button. If the manual mode is selected while the vehicle is not moving, the starting gear will be maintained until the driver requests a shift. In down- hill situations in particular, the driver must be alert to vehicle speed by downshifting and/or using the ser- vice brakes as needed. A shift request will be refused if the selected gear would cause engine overspeed or excessive lugging. Fig. 15.3, Gear Indicator: Reverse Low Gear IMPORTANT: Under normal conditions, do not select reverse with the vehicle moving forward.

The vehicle must be moving at less than two miles per hour (3 km/h) before selecting reverse. If reverse is selected when the vehicle is moving faster, an au- dible alert will sound and continue sounding at three- second intervals until the vehicle slows to the proper speed or the driver selects the drive mode. Low Mode Low mode should be used to maximize engine brak- ing and minimize the use of the brake pedal. It is most useful when descending steep hills or when coming to a stop. Engine speed will be increased by 200 rpm and shift points will be offset by 200 rpm. To upshift, press the upshift arrow button on the shift selection module; to downshift, press the downshift arrow button.

See Fig. 15.1 . A shift request will be refused if the selected gear would cause engine overspeed or excessive lugging. To select low mode, press the low mode button (LOW) on the shift selection module. When in low, 15.2