Western Star — Western Star (EN)

Automated and Automatic Transmissions the current gear is maintained. Requests to upshift are not enabled. IMPORTANT: If the engine is approaching over- speed, the transmission controller will override the current gear setting and upshift to prevent engine damage. If low mode is selected from neutral while the vehicle is stopped, the vehicle will start up in first gear and stay there until the engine approaches overspeed. Neutral IMPORTANT: Always start the engine with the transmission in neutral (N) and the parking brake set. 10/13/2003 f610678 Fig. 15.4, Gear Indicator: Power Up Dot Display WARNING Do not coast in neutral.

Coasting in neutral can cause an accident, possibly resulting in severe personal injury or death. Neutral is always available during operation, what- ever the vehicle speed. When in neutral, requests to upshift or downshift are ignored. If the driver selects drive mode while the vehicle is moving in neutral, the transmission will shift into the appropriate gear given the engine speed. When shifting from neutral, always depress the brake pedal. If the brake pedal is not depressed, the trans- mission will not shift and an audible alert will sound. To reset the transmission, select neutral again and attempt the shift again, this time with the brake pedal depressed. 10/13/2003 f610679 Fig.

15.5, Gear Indicator: Neutral 3. On vehicles with an AutoShift transmission, de- press the clutch pedal all the way to the floor. Before shutting down the engine, return the transmis- sion to neutral. 4. Apply the service brake and start the engine. Powering Up 5. On vehicles with an AutoShift transmission, re- lease the clutch to allow the speed sensor on the input shaft to get a reading, then depress the clutch pedal again. 1. With the parking brake set, turn the ignition switch on and allow the shift selection module to power up. The gear indicator will show the dot display, arranged in a square pattern. All dots in the pattern should light up, without gaps or spaces. See Fig. 15.4 . NOTE:

When in drive mode, the transmission defaults to second gear when starting off. If de- sired, the driver can select to start off in first gear. No other start gear is available. 2. Wait for the gear indicator to show a solid N. See Fig. 15.5 . When the N is solid (not flashing), the transmission controller is powered up. 6. Select the desired mode (drive, manual, low, or reverse), then select the desired starting gear. 15.3