Automated and Automatic Transmissions WARNING Downshifting To request a downshift, push the downshift arrow button on the shift selection module. If the gear is available, the transmission will downshift and the new gear will display on the gear indicator. If the gear requested is unavailable, a tone will sound. When starting or stopping on hills and grades, use extra care to prevent the vehicle from rolling back. A rollback accident could cause death, seri- ous personal injury, or property damage. 7. On a level grade, release the parking and ser- vice brakes. Before starting down a hill, downshift to a speed that you can control without hard pressure on the service brakes.
Before entering a curve, downshift if neces- sary. This lets you use some power through the curve to help the vehicle be more stable in the turn. It also allows you to regain speed faster as you come out of the curve. 8. Move the vehicle forward by doing one of the following: Vehicles with an UltraShift transmission: depress the accelerator pedal. Vehicles with an AutoShift transmission: release the clutch and depress the accel- erator pedal. NOTE: The AutoShift transmission is able to perform triple downshifts when the next three lower gears are available and conditions are appropriate. Powering Down 1.
On vehicles equipped with an Autoshift transmis- sion, depress the clutch pedal to the floor. Skip shifts can be performed only in manual mode. To skip shift, press the downshift button twice or three times. The number of the gear engaged will appear on the gear indicator. 2. Bring the vehicle to a halt For best engine braking, select low mode while mov- ing. In low, downshifts are performed at higher rpm than in drive. 3. Apply the service brakes. 4. Select neutral (N) on the shift selection module. When the N on the gear indicator is solid (not flashing), the transmission controller is ready to power down. IMPORTANT:
If the engine is approaching over- speed, the transmission controller will override the current gear setting and upshift to prevent engine damage. 5. Set the parking brake and shut down the engine. Upshifting Transmission Diagnostics Clutch Protection Fault, UltraShift Transmissions To request an upshift, push the upshift arrow button on the shift selection module. If the gear is available, the transmission will upshift and the new gear will display on the gear indicator. If the gear requested is unavailable, a tone will sound. Even though a vehicle with an UltraShift transmission does not have a clutch pedal, it does have a me- chanical clutch.
As you slowly increase and decrease engine rpm from a stop, the mechanical clutch is en- gaging and disengaging, just like slipping the clutch with a manual transmission. Excessive clutch slip- page creates heat and reduces the life of the clutch. Conditions that can cause clutch damage include: Upshifts are not available in low mode, except to pre- vent engine overspeed. NOTE: The AutoShift transmission is able to perform triple upshifts when the next three higher gears are available and conditions are appropriate. Using the accelerator pedal to hold the vehicle on a hill Skip shifts can be performed only in manual mode. To skip shift, press the upshift button twice or three times.
The number of the gear engaged will appear on the gear indicator. Starting the vehicle from a stop in a gear that’s too high Overloading the vehicle 15.4