Western Star — Western Star (EN)

Automated and Automatic Transmissions Using high idle with the vehicle in gear appear on the gear indicator when the vehicle is re- started. The transmission controller is programmed to prevent clutch damage. When the clutch overheats, the fol- lowing alerts take place: Complete the following steps. 1. Set the parking brake. The TRANS TEMP light comes on 2. Turn off the ignition and wait at least two min- utes. The gear indicator displays "C," then "A" The alerts continue until the clutch cools, the accel- erator pedal is released, or the clutch is fully en- gaged. A warning tone sounds at one-second intervals 3. Depress the brake pedal and release the parking brake. 4.

On vehicles with an AutoShift transmission, de- press the clutch partway to the floor. System Problem 5. Select neutral by pressing the neutral button (N) on the shift selection module, then turn on the ignition key. Do not attempt to start the engine yet. In the event of a problem, complete the following steps. 1. Note the driving conditions at the time the prob- lem occurred. 6. Release the pressure on the brake pedal slightly. 2. Record the status of the transmission at the time of the problem (current mode, current gear, en- gine speed, etc.). 7. Once the transmission is in neutral, a solid N will appear on the gear indicator and the vehicle will start.

Apply the service brakes and start the en- gine. 3. Complete the transmission reset procedure. 8. If the gear indicator continues to display a dash, contact an authorized Western Star or Eaton ser- vice facility. Transmission Reset Procedure In some cases, proper transmission operation can be restored by resetting the transmission controller. Allison Automatic Transmissions 1. When it is safe to do so, stop the vehicle. 2. Select neutral by pressing the neutral button (N) on the shift selection module. Refer to the Allison website for additional information ( www.allisontransmission.com ). 3. Set the parking brake. 4. Shut down the engine. General Information, Allison Transmissions 5.

Wait at least two minutes. 6. Restart the engine. HD-series automatic transmissions have six forward speeds and one reverse speed. These transmissions have electronic shift controls that can be pro- grammed to allow the use of different numbers of geared speeds. For instance, the transmission can be programmed to operate as a 4-speed, 5-speed, or 6-speed unit in the "primary" shift mode. If needed, a "secondary" shift mode can be programmed to pro- vide another shift configuration to optimize vehicle use under different operating conditions. 7. If the problem continues or the transmission doesn’t achieve neutral after power-up, contact an authorized Western Star or Eaton service fa- cility.

Locked In Gear If the vehicle is shut down while in gear, the trans- mission may become locked in gear. The transmis- sion will attempt to get to neutral during the next power-up if neutral is selected on the shift selection module. If neutral can’t be achieved, a dash will To activate a secondary shift mode, or other special functions programmed into the electronic control unit (ECU), press the Mode button. See Fig. 15.6 . "MODE ON" is displayed in the indicator panel just 15.5