Western Star — Western Star (EN)

Fifth Wheels wheel inspected and adjusted by a certified technician. For a low-lube fifth wheel plate , the fifth wheel must slide freely under the trailer, and the trailer should contact the fifth wheel at the pivot. See Fig. 17.5 . Coupling, Jost Fifth Wheel NOTE: For a tractor equipped with a Fontaine or Holland fifth wheel, see the heading Cou- pling, Fontaine and Holland Fifth Wheels above. 1 2 1. Tilt the ramp down. 2. Open the kingpin locks. See Fig. 17.7 . 03/10/99 f610291 A 1. Trailer Air Supply Valve Knob 2. Parking Brake Valve Knob Fig. 17.8, Brake Valve Knobs 8. Back the tractor under the trailer. For a standard fifth wheel plate , the fifth wheel must lift the trailer.

For a low-lube fifth wheel plate , do not lift the trailer as this may damage the fifth wheel plate. 09/10/2010 f311128 A. Lock held open by catch mechanism 9. After sliding under the trailer, stop to avoid hitting the kingpin too hard, then resume backing slowly until the fifth wheel locks. Fig. 17.7, Jost Release Handle Unlocked 3. Back the tractor close to the trailer, centering the kingpin on the fifth wheel. 10. Set the tractor parking brake. WARNING 4. Chock the trailer tires. 5. Connect the air lines and electrical cable. 6. Ensure that the trailer air supply valve (trailer brake) is pulled out, and that the trailer parking brakes are set. See Fig. 17.8 .

A visual inspection is required by law. Some im- proper couplings can pass a pull test. Sound is not reliable. Get out of the cab and look. Incor- rect coupling could cause the trailer to discon- nect, possibly resulting in serious personal injury or death. NOTICE 11. Perform a physical check for positive kingpin lockup, ensuring that there is no gap between the trailer and the fifth wheel. See Fig. 17.6 . Attempting to couple at the wrong height may cause improper coupling, which could result in damage to the fifth wheel or kingpin. 12. Ensure that the release handle is in the locked position adjacent to the casting. See Fig. 17.9 . 7. Adjust the trailer height (if required).

For a standard fifth wheel plate , the trailer should contact the fifth wheel approximately 4 to 8 inches (10 to 20 cm) behind the pivot. See Fig. 17.4 . 13. Release the tractor parking brake and test for kingpin lockup by slowly moving the tractor for- ward, pulling on the trailer against the chocks. 17.4