Fifth Wheels For a standard fifth wheel plate , the trailer should contact the fifth wheel approximately 4 to 8 inches (10 to 20 cm) behind the fifth wheel pivot. See Fig. 17.4 . When lockup has occurred, the fifth wheel con- trol handle moves to the locked position. Make sure that the safety latch is down over the lock control handle to hold the control handle in the locked position (the safety latch will only rotate down if the operating rod is fully retracted in the locked position). See Fig. 17.2 or Fig. 17.3 . For a low-lube fifth wheel plate , the fifth wheel must slide freely under the trailer, and the trailer should contact the fifth wheel at the pivot. See Fig. 17.5 .
B A B 09/10/2010 f311126 A. No gap between trailer and fifth wheel B. Kingpin inside lock Fig. 17.6, Coupling Inspection A 9. Release the tractor parking brake. Test for king- pin lockup by slowly inching the tractor forward, pulling on the trailer against the chocks. 09/10/2010 f311125 A. Adjust trailer height B. Ramps tilted down 10. After lockup is completed, connect the tractor-to- trailer air system lines and the electrical cable to the trailer. Take care to prevent dirt or foreign material from entering the air system lines. Fig. 17.5, Trailer Connection Point, Low-Lube Fifth Wheel Plate 6.
With the fifth wheel lock opening aligned with the trailer kingpin, back the tractor slowly toward the trailer. After sliding under the trailer, stop to avoid hitting the kingpin too hard, then resume backing slowly until the fifth wheel locks. NOTICE Always make sure the connection hanger keeps the trailer air hoses and electrical cables posi- tioned so that they do not rub on anything. Rub- bing may wear through hoses or cables, resulting in air leaks, or exposed or broken wires, poten- tially affecting trailer brake or electrical systems. For a standard fifth wheel plate , the fifth wheel must lift the trailer.
For a low-lube fifth wheel plate , do not lift the trailer as this may damage the fifth wheel plate. 7. Set the tractor parking brake. 11. Charge the air brake system and check that the air connections do not leak. WARNING WARNING A visual inspection is required by law. Some im- proper couplings can pass a pull test. Sound is not reliable. Get out of the cab and look. Incor- rect coupling could cause the trailer to discon- nect, possibly resulting in serious personal injury or death. Incorrect fifth wheel lock adjustment could cause the trailer to disconnect, possibly resulting in se- rious personal injury or death. 12.
With the trailer tires chocked and the brakes set, check for clearance between the kingpin and the fifth wheel jaws by moving the tractor forward and backward against the locked kingpin. If slack is present, uncouple the trailer and have the fifth 8. Perform a coupling inspection, checking that there is no gap between the bottom of the trailer and the fifth wheel, and that the kingpin is se- curely locked. See Fig. 17.6 . 17.3