Western Star — Western Star (EN)

In An Emergency jurisdictions now issue fines for draining fuel/ water separators onto the ground. VENT CAP FOR REMOVAL OF TOP COLLAR ONLY 2. Put a clean receptacle under the fuel/water sepa- rator and attach a piece of hose to the drain valve, to direct fuel into the receptacle. NOTE: Use a hose with a Ѕ-inch pipe thread to fit the drain valve on a Fuel Pro 382. 3. Remove the vent cap ( Fig. 21.2 , Item 4) and open the drain valve ( Fig. 21.2 , Item 1). Drain the fuel to just below the collar level, then close the drain valve. 02/16/2009 f470277 Fig. 21.3, DAVCO Collar Wrench the fuel/water separator from sealing, and an air leak will result. 7. Ensure that the drain valve is closed. 8.

Remove the filter grommet from the filter stud, if equipped. 5 9. Fill the housing to the top with clean diesel fuel. 10. Install a standard engine spin-on filter (part num- ber FF105 or equivalent) on the filter stud. 2 6 11. Install the cover O-ring, clear cover, and the col- lar. Hand-tighten the collar. 12. Install the O-ring in the vent cap, then install and hand-tighten the vent cap on the fuel/water sepa- rator. f470506b 05/05/2009 1. Drain Valve 2. Lower Housing 3. Clear Cover 4. Vent Cap 5. Collar 6. Inlet Port/Check Valve 13. Start the engine.

When the lubricating oil reaches its normal operating pressure, increase engine speed to high idle for one to two minutes to purge air from the system. Fig. 21.2, DAVCO Fuel/Water Separator (Fuel Pro 382 shown) Starting with Jumper Cables 4. Using a DAVCO collar wrench ( Fig. 21.3 ), re- move the clear cover and collar. WARNING NOTE: Broken vent cap and collar warranty claims will not be accepted if any tool other than a DAVCO collar wrench, p/n 380134, 382002, or 232007, is used for removal. During installation, the vent cap and collar are to be hand- tightened only , not tightened with a wrench. Batteries release explosive gas. Do not smoke when working around batteries.

Put out all flames and remove all sources of sparks or intense heat in the vicinity of the battery. Do not allow the ve- hicles to touch each other. Do not lean over the batteries when making connections, and keep all other persons away from the batteries. Failure to follow these precautions could lead to severe personal injury as a result of an explosion or acid burns. 5. Remove the filter and dispose of it in an environ- mentally acceptable manner. 6. Clean all threads and sealing surfaces very thor- oughly. Even a small amount of dirt will prevent 21.2 4 1